• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

6-pin JPT male connector

S

sekokupu

Member
Joined
Sep 11, 2006
Location
Finland
Does those things exist? Would be easy way to do MAF extension but is the only way to butcher old MAF only for connector?
 
OH! Wow, apologies, I read that totally wrong.

I'm coming up with no male side results for now, but I'll dig around a bit more.
 
Last edited:
That connector does not exist. You CAN find a 5 pin JPT connector and just transfer the pins or grab the gray connector on the DS strut tower from an 850. The pins will swap into that.
 
I just didn't want to broke or cut that connector, still not sure where maf will be located on my setup.

But my solution was to extract those JPT pins with special tool (stole some bobby pins from bathroom, great things for that job), and bought newer style sealed connector which still uses same JPT pins for extension (used old pins for new housing): http://www.finjector.com/verkkokaup...ector_pair_1_5_2_5_mm2_jpt_pins-p-522159-231/
 
You must log in or register to reply here.
Back
Top