• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Coolant switch for e fan conversion?

Joined
Nov 22, 2017
Location
California
So I finally decided to do my electric fan conversion, but don't know what temp switch to do. Ideally, a 2 temp switch for both high and low speed would be best. The BMW one seems to have a little too high temps.

Reading through some threads, I found this one: https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/151876924236

It seems like it would work perfectly since in one pic, it has 85 and 93, which I assume are the switch temps for low/high and the thread pitch seems to be the same as my Vernet single temp switch, 22x1.5. Has anyone used this switch?

9TtgL.jpeg

With the notch downwards, the terminals apparently go ground - low - high
 
Last edited:
Back
Top