• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Official LH2.4 EZK Wasted Spark Conversion - Installation Instructions

I have unlimited supply of Audi A4 2.0T ign. coils with built in ignitors if anyone needs them for MS or 16v setups. i don't know if anyone needs them, but i have like, ****s loads of them. lol
 
hi, anybody have the partnr on the mazda ignitionmodule that will give out the tachometer signal and also work with the bosch 2x2 coil with the buckha card? :)
 
if anybody else thinks this is usefull:

getimage.php

the J702T ignition module for Mazda MX5 \ Miata
Mazda Partnr: B61P18251
cost aprox: 4800 NOK (Norwegian Kr) in dollar aprox depending on the currency: 800$
 
Got it:
Originally Posted by DNAsEqUeNcE
OC1 Output coil bank 1 (to 1-4 side of your coils)
IB1 Ignition bank 1 (from buchka spark 1-4
VB Voltage Battery 12+ switched
TAC Tacho output straight to your 240 tach if miata unit, IF dsm unit, wire in a 12+ pullup wire with 1k ohm resistor tied into tach line)
IGR 12+ passthrough (unused)
GND Self explanitory
IB2 Ignition input 2 (to 2-3 side of your coils)
OC2 Output coil 2 (from buchka spark 1-4)
 
Last edited:
Back
Top