b234f yoshifab plenum/ throttle cable

hi I am in the process of welding up the yoshifab plenum and I am noticing that while it fits of course it is quite close to the throttle cable housing on the fire wall and as I am not running sold engine mounts I was wondering if anyone else has noticed/ had this problem. I should note that I am welding the plenum just after the runners mainly because its a lot easier to weld this way, and because I want to keep the vacume niples for IAC and various other things.

thanks

Here is how he did it back when he made them and sold them already made..

sbabbs said:

Here is how he did it back when he made them and sold them already made..

Click to expand...

thank you, as you can see here he is welding the plenum at the runners, I am doing something slightly different. I want to know if anyone has had any problems with the engine torquing into the throttle cable at the fire wall as there is not a lot of space.

Under acceleration the engine will torque over to the pass side.

Do you have a pic of your current setup?

Electric throttle is one way. Takes care of idle too.

I know the welds arn't beautiful but it was the first time using the gun. as you can see the throttle is touching
<img src="https://i.ibb.co/6mCCndV/99439592-2988874994500861-4569373752973852672-n-2.jpg" alt="99439592-2988874994500861-4569373752973852672-n-2" border="0"><img src="https://i.ibb.co/G5DBBp6/99099804-2647454788871241-293111718152765440-n-1.jpg" alt="99099804-2647454788871241-293111718152765440-n-1" border="0">