doucheNozzle
Newbie
- Joined
- Feb 26, 2009
- Location
- The Pitt, 15147
Yeah the cheap eBay alternative to the part that the OP stated he wanted "might be worth a shot". i never told the guy he should do anything.
K.
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
Yeah the cheap eBay alternative to the part that the OP stated he wanted "might be worth a shot". i never told the guy he should do anything.
Why?
Add wideband to your list would be more beneficial.
Have a wideband already, see 16v turbo project details in my sig.
Future mods must support more for more! 42lb delphis with a 4bar regulator should comfortably get me enough fuel for 300+ hp.
The Dodge Turbo FPR that I found is actually rated at 55 psi (3.8 Bar).
What part number have the proper spray pattern? I haven’t found any that are drop in that work with single ports after going through the whole Bosch Injector Data work sheet that are actually readily available.
I'm running Bosch 0 280 155 811 white composite body injectors from Supercharged Buick 3800 V6. These are 4-hole type, work fine in your single intake port, have better atomization than Bosch Gen I injectors. One note these injector were also used in LS 3 engines at higher psi. I've found these to work best on my 88 765 Turbo using an engine coolant temp sensor from a BMW, Bosch 0 280 130 023, this sensor has a white insulator.