Maligantblue
New member
- Joined
- Jul 22, 2015
Hi
So im looking to make a cam sensor for my red block.
Was planning on putting a Hall sensor onto the timing belt cover to detect a bolt put through the cam pulley, that would line up at Top dead center.
Thing is there isn't much room for the other end of the bolt between the pulley and the head.
Short of welding a pick up onto the pulley, what could i do for a relatively simple cam sensor?
How did you do your own? (for those who have obvs)
its going on, for an input to a standalone ecu to run coil packs.
Manythanks.
Mal
So im looking to make a cam sensor for my red block.
Was planning on putting a Hall sensor onto the timing belt cover to detect a bolt put through the cam pulley, that would line up at Top dead center.
Thing is there isn't much room for the other end of the bolt between the pulley and the head.
Short of welding a pick up onto the pulley, what could i do for a relatively simple cam sensor?
How did you do your own? (for those who have obvs)
its going on, for an input to a standalone ecu to run coil packs.
Manythanks.
Mal