740 Any use NGK (54216) EUX010 Spark Plug Wires?

anyone run these in their redblock?
my Bougicord's wire for plug 1 wont snap on the plug like the other 3. might have to cut the boot a bit to make it fit right or just get a new set, don't know how old the one on my car is. got new plugs, cap and rotor so might as well get new wires.

NGK (54216) EUX010 Spark Plug Wire Set

https://www.amazon.com/NGK-54216-EUX010-Spark-Plug/dp/B001RM7YUO

I have run them on our chump car.. Seem to hold up well.

-Sam

got them on my car! runs good.

Hello everyone,

I'm confused here. I got this NGK set from Amazon, exactly this same one, I purchased from the Amazon link above.

And the distributor side does not fit.
I have a rear of the block mounted distributor on a 96', 2.0t, 940.

Here is an image, on the left is the distributor terminal of the new NGK cable, on the right is the one from the bougicord that I'm currently running. They are clearly not the same. Please help.

https://pasteboard.co/ItPSEXO.png

Thanks in advance,
Matthew.

Bump for help. Anyone?

BTW, this is the terminal on my distributor (same as the one in the coil)

https://pasteboard.co/ItVYOp5.jpg

Bougicord snaps nicely on it, the NGKs do not, obviously.

I just want to buy a set of nice and fat silicone wires to go with my BPR7ES NGK plugs (got the ones with the solid, non-screw off, terminal heads)

NGK 3785 BPR7ES SOLID Standard Spark Plug -

https://www.amazon.com/dp/B01DMFHL5Q/ref=cm_sw_r_cp_apa_i_NTXxDbWE9BCZ7