• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

b230 Lh2.4 injector sizes for <200 bhp n/a

A

Avtovaz

New member
Joined
Nov 12, 2010
Im building a 2.3 b230, itll be about <200 bhp, not sure of the torque, but itll have a 298 deg cam in it. I must use the standard lh2.4 inlet, and the one i bought from ebay was from a turbo, so the injectors are Low impedance.

Im looking at high impedance ones for the set up of ecu i want to run.

Can someone suggest injectors for the manifold that will suit my application?

I cant use any different set up,

thanks
 
Hi, your turbo injectors should be fine if you use them with the volvo resistor pack.
 
thats the thing, im not using it in a volvo! B230 in a bmw e36 rally car with bmw m44 ecu... Bmw uses high impedance injectors... Its a rally rule that i have to use the standard inlet for the engine if on injection... No turbos or anything good like that!!
 
I have t5 injectors, 391cc at 3.8 bar, I believe these are high independence as I did the resistor bypass. Unless I've got it mixed up...correct me if I'm wrong. So you wouldn't need a resistor and its a better spray pattern than the normal turbo injectors
 
You must log in or register to reply here.
Back
Top