supreme940
Member
- Joined
- Nov 15, 2014
- Location
- MA
So I have a yoshifab bracket with a set of D514A ls2 coils that I want to use on my 940. I already have a running EDIS/J702T setup, so I figured it'd be easy to wire over the LS coils.
I made up a harness that uses the stock coil wires and the two ezk outputs. I used a dummy relay to get back the tach signal, and wired it all up and installed it, however there was no spark even after switching the two signal wires. This is how I have them wired up:
After trying, I switched back to my EDIS and it works fine. Anybody know why it wouldn't work / how to wire them up if you're running them?
I made up a harness that uses the stock coil wires and the two ezk outputs. I used a dummy relay to get back the tach signal, and wired it all up and installed it, however there was no spark even after switching the two signal wires. This is how I have them wired up:
After trying, I switched back to my EDIS and it works fine. Anybody know why it wouldn't work / how to wire them up if you're running them?
Last edited: