• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Official LH2.4 EZK Wasted Spark Conversion - Installation Instructions

With my Buchka Board installed...I'm not getting enough voltage to Igniter.

Wasted Spark Leads off the board show 0.08-0.1v while cranking...that's not lighting off the igniter.

Any advice?
 
Checking in...

Car runs like a bat outta hell!

I'm getting NO TACH signal from my J702t igniter...bummer, as it's the whole reason I chose it.

Wonder if it's bad or if it's with my car/tach.
 
Glad the car's running for you, seems like a good product. Now if I could only figure something out about where mine is at...
 
That's the miata amp right everyone seems to be using it just fine. Brett used it just fine I think?

Yep, Miata amp...I used it for this feature...

I'm going to have to do some testing, this weekend to see where the problem is...

Could be bad cluster wiring, as well....
 
I used the miata amp in my car and it worked just fine on the stock tac. If I remember correctly there is a pullup wire you may have to splice in as well to get your particular tach working properly. I'm gonna go look at my notes from when I ran mine
 
Back
Top