View Single Post
Old 03-03-2021, 07:05 AM   #3
Beep beep zip tang
VB242's Avatar
Join Date: Sep 2011
Location: The Right Coast

Originally Posted by dl242gt View Post
This should be the setup where it's a sealed bearing with the hub included. At least that is how they were when I did them on a 88 760 which should be the same. It's held on with a large nut. I imagine if the bearings got hot then you may need a puller to get the hub off. But when I did them they slid right off the spindle after removing the nut.

PS I am only referring to the front. If you mean the rear bearings. I'm pretty sure you need a puller to get them out.
Sorry yes, it's for the rear, fronts are already done. I got 2 big sealed double row roller bearings from Rock auto.
Originally Posted by 240240 View Post
I'm shocked someone actually took me seriously.
VB242 is offline   Reply With Quote