iHateVolvoPeople
Active member
- Joined
- Feb 1, 2014
- Location
- Midwest
You got my setup below.
I run at 1,7 bar boost (24psi) with D cam and it revs good to 6k rpm. 313HP
Are you making that 300hp on a stock bottom end skinny rod motor??
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
You got my setup below.
I run at 1,7 bar boost (24psi) with D cam and it revs good to 6k rpm. 313HP
Are you making that 300hp on a stock bottom end skinny rod motor??
Yes sir and it is abused quite often.
It's all marketing wank
Not entirely true. Rods are subject to stress. When they're subject to stress in the realms of their yield strength they fatigue. When the fatigue, eventually they fail. Even if they could handle that amount of force in an unfatigued original state. Where this power/torque soft "cap" is, who knows, but it's there.If everyone used wasted spark, semi sequent injection and fully adjusted ignition map, there should be no problrms.