VB242
I.M. Weasel
- Joined
- Sep 21, 2011
- Location
- Driving the No Malarkey Bus
So I've installed a DSM CAS with the Yoshi hi res trigger wheel. I'm using Toyota cops running as wasted spark.I have 12v to plug, I'm reading 4.92v on the sensor plugs from to the 5v vref/1k pull up resistors spliced in. At first I was getting some weird low rpm reading on the tuner studio tach, like 31rpm or 93rpm where I let the key off after cranking but no reading during cranking. The battery was pretty low and it was dropping down to 8v or so. I put the charger on the battery and am now at least getting an rpm signal and the injectors are firing but no life from the engine. I have the trigger wheel set like the picture in gross polluters write up and 10? offset. I found a different thread last night from GP that said he recommended a 60? angle now. I will try this tonight and try to set the cam slot to 60? past the sensor, is this correct? The battery should have a full charge now as well.
The main issue I'm having though is with tuner studio. I have my cooling fan running on WLED. I have 1& 4 coils hooked to spark output A and 2&3 hooked to spark output B. It's throwing an error when I open the tune, saying I have a conflict with the spark outputs and the optional outputs. Then the cooling fan comes on and stays on until I disable the optional output and go into the testing mode and turn it off manually. I've reflashed the controller several times. Once I reload the tune after the reflash everything is fine until I cycle the key off and back on then I get the conflict. Is the controller bad or am I doing something wrong?
The main issue I'm having though is with tuner studio. I have my cooling fan running on WLED. I have 1& 4 coils hooked to spark output A and 2&3 hooked to spark output B. It's throwing an error when I open the tune, saying I have a conflict with the spark outputs and the optional outputs. Then the cooling fan comes on and stays on until I disable the optional output and go into the testing mode and turn it off manually. I've reflashed the controller several times. Once I reload the tune after the reflash everything is fine until I cycle the key off and back on then I get the conflict. Is the controller bad or am I doing something wrong?