AndrewTheHobbit
Member
- Joined
- Nov 5, 2017
- Location
- Seattle, WA
UPDATE
https://ibb.co/P96yGJY [url]https://ibb.co/Wcz3vhj https://ibb.co/ZLjL2DG https://ibb.co/6ZTVHVx https://ibb.co/KDXJPGg[/URL]
I am a madman.
the m47 and cd009 pre bellhousing and input shaft cut.
after cut just the cd009
Working on a relocation deal so i can get the shifter to roughly come out here:
Cardboard debauchery, plate on top is 6.5" x 6.5" square, for now, with the bracket on the right side of the CD being spaced out an inch to clear the top of the trans :
Gotta shorten and weld these two pieces together next and figure out how to cut and get this piece of the original shift turret to connect.
Updates will happen at some point along the process
UPDATE! 11/2/18
test fit done sans clutch and pressure plate, Deeworks CD009 to redblock adapter, working on a shifter setup for the stock location. just a little bit of banging on the trans tunnel for clearance otherwise fits like a glove! Will update more tomorrow on the cross-member modification and clearance for the tunnel.
2f"><img src="https://thumb.ibb.co/hppk2f/45256699-747467898932767-166529939493879808-n.jpg" alt="45256699-747467898932767-166529939493879808-n" border="0"></a> <a href="https://ibb.co/cwNSF0"><img src="https://thumb.ibb.co/cwNSF0/45328001-358298011574388-7621189209260294144-n.jpg" alt="45328001-358298011574388-7621189209260294144-n" border="0"></a>[/IMG]
https://ibb.co/P96yGJY [url]https://ibb.co/Wcz3vhj https://ibb.co/ZLjL2DG https://ibb.co/6ZTVHVx https://ibb.co/KDXJPGg[/URL]
I am a madman.
the m47 and cd009 pre bellhousing and input shaft cut.
after cut just the cd009
Working on a relocation deal so i can get the shifter to roughly come out here:
Cardboard debauchery, plate on top is 6.5" x 6.5" square, for now, with the bracket on the right side of the CD being spaced out an inch to clear the top of the trans :
Gotta shorten and weld these two pieces together next and figure out how to cut and get this piece of the original shift turret to connect.
Updates will happen at some point along the process
UPDATE! 11/2/18
test fit done sans clutch and pressure plate, Deeworks CD009 to redblock adapter, working on a shifter setup for the stock location. just a little bit of banging on the trans tunnel for clearance otherwise fits like a glove! Will update more tomorrow on the cross-member modification and clearance for the tunnel.
Last edited: