sksmith
Active member
- Joined
- Nov 14, 2007
- Location
- Back in St. Louis, MO
So a few years back, I picked up a set of lowering springs from VP Autoparts for my 73 142.
I'm messing with the rear & underside of the car at the moment, and noticed that my existing springs are flat on the bottom, and not pigtailed like the VP springs.
Looks like a need the lower anchorage washer & nut. VP doesn't list the part number shown on the GCP.se -72 catalog, but shows P/N 1206811. Would this be the correct retainer to make these springs work with my later lower control arms?
Thanks,
Steve
I'm messing with the rear & underside of the car at the moment, and noticed that my existing springs are flat on the bottom, and not pigtailed like the VP springs.
Looks like a need the lower anchorage washer & nut. VP doesn't list the part number shown on the GCP.se -72 catalog, but shows P/N 1206811. Would this be the correct retainer to make these springs work with my later lower control arms?
Thanks,
Steve
Last edited: