home register FAQ memberlist calendar

Go Back   Turbobricks Forums > Mechanical > maintenance & nonperformance

Reply
 
Thread Tools Display Modes
Old 06-14-2018, 04:32 AM   #1
244_502
Newbie
 
Join Date: Dec 2017
Location: Guatemala
Default Injector Voltage // CAOPS @ Relay - No Start

No Start on a B230FT Swap Carbd 1982 244---> 1989 LH 2.2 740T B230FT

Im reading 12v on both sides of injector plug, with ignition in position "II" -- normal?
Im reading 12v at 86/2 on pump relay in position "II" -- normal?

Normal? Or is ECU not grounding injectors? As far as I can understand on diagrams, 86/2 should not have voltage in run position.

The 740 harness was an absolute mess with many improper connections prior to swap, and evidence of previous issues (melted #1 fuse, browned around 30 pin on relay, butchered suppression relay/ ECU looks to have been opened up for unknown reasons)

I've re-verified wiring and all connections look sound and as they should be.

Perhaps a bad ground?

Any help/insight is very much appreciated!
244_502 is offline   Reply With Quote
Old 06-15-2018, 10:01 AM   #2
EivlEvo
Board Member
 
Join Date: Sep 2012
Default

Just to be clear...

You swapped an entire motor and ECU setup together? As in you've effectively taken one car and moved it into another? Or are you playing mix and match?

The first sentence is a bit mis-leading.
EivlEvo is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -4. The time now is 09:14 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.