euro-trash97
Member
- Joined
- May 8, 2015
- Location
- Virginia
Im trying to put a trutrac in my 240 but I dont have a tone ring, where can I buy one?
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
You can also just cut the tone ring teeth into the housing with an angle grinder. There's lots of meat there, and you don't have to be *super* precise for it to work.
Was that yours i did, Ben? I remember doing 2 or 3, i think Steve?s worked ok, anothere had needle bounce.
Definitely not my favorite method.
You did towerys and mine, neither worked well at all.
I haven't had good results with that.
Worked great for our ABS; possibly the duty cycle is wrong / bad for the 12t speedo?
I think that?s it.
With a 48t wheel (stock) the teeth width and gap width is almost exactly the same (maybe it is the same?)
12t is waaaayyyy different.