Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
Thanks for the reply! Looks like that's it but can not find it anywhere.
So, basically, just a flat sheet of non-conductive plastic, 3 mounting holes, 1 connector pass-through, and a big hole in the middle for the ring to crimp to (fold over the 4 tabs).
Carve one out of a plastic milk jug? Nah, too flimsy.
Buy a 3D printer? Too expensive.
Flat Tupperware food storage lid? Hmmmm.....