• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

940 Need manual reset procedure for SRS after airbag deploy

Jake

Jake

Lays Down the Thunder
Joined
Mar 27, 2003
Location
the Hartbeat
Back in August, my daughter bumped a car from behind in her 945 and the airbag blew. It has been replaced but the shop can't locate the procedure to turn off the SRS warning light. Anyone have that knowledge? Thanks!
 
I would read the codes. There is likely still a problem. Most SRS systems do a self-test each key cycle. If there is an issue, the light stays on.

You could have something like an open in the coil spring.
 
ZVOLV said:
I would read the codes. There is likely still a problem. Most SRS systems do a self-test each key cycle. If there is an issue, the light stays on.

You could have something like an open in the coil spring.
Click to expand...

Thanks, I instructed him to read the codes prior to and after resetting and I'll reinforce that based on your suggestion.
 
The SRS light may go out if the self check didn't see a problem but previously triggered code can stay in the memory for some time until it is manually erased
 
You must log in or register to reply here.
Back
Top