impolvo
Is always busy
- Joined
- Feb 23, 2006
- Location
- Chapel Hill NC
I know I'm missing something because the fan will only turn on when I have the + on the temp switch grounded.
As this point, I'm ready to put the clutch fan back on until I can figure this out.
I pulled the fan setup out of a late 960.
i think i might see your problem-- 1-and 2 on the relay must ground to turn on
therefore the temp switch must ground
#2 is high speed
so relay 2--- to one prong on the temp switch-- the other prong on the switch to ground
assuming its a 2 prong switch-- if not then 3rd prong ground
if 3 prong then 1- to lower temp, 2 to upper