• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Passenger side Front Turn signal not working

To all who are having this issue

To anyone who is encountering this issue.

If your turn signals have any kind of visible corrosion, and one side works and the other side doesn't...

Use a steel wool on your corroded parts. Before checking the blinker relay(if it works on one side and not the other it's most likely not your relay), before looking for shorts or grounds.

Just scrub the contacts for the bulb socket out really good with a steel wire brush, and the metal part of the bulbs themselves if you don't want to buy new ones.

If you are curious about your turn signal bulb socket assembly not working, you can swap out the right and left sides to test them. That will tell you for sure... That you just need to use a steel wool and help with the contacts.

Someone else mentioned somewhere that the bulb socket assemblies can fall apart due to a manufacture defect(like the f*ing exterior door handle springs loosening). That may be the case as well, all he needed to do to fix his issue was sodder the lines around the casing to the socket, but I would recommend just replacing the socket if the steel wool doesn't work.

So remember - If scrubbing doesn't work... Then go investigate the grounds / relays
You will save yourself a lot of time by doing this.

Fin.
 
Last edited:
Back
Top