okay so i made a list of stuff i need to do/fix, might as well put it up here:
Its fun you'll never get bored with a old car.. then again when i all do this it be much faster/cleaner looking then stock ever was
Rust(only plates no real damage done luckily:
-Behind the headlights
-Engine bay near the airco dryer
-Danger-to-the-manifold *In progress*
-Sunroof, the closing stays wet, so ill have to replace that too *Fixed*, just surface rust, sanded and coverd in white paint that eats the rust and turns it into lead"
-trunk, done but needs a few welds to cover up the holes that remained
-some small spots not yet rusted near the wheels
-Sidemarker driver side *done* just surface rust, needs new paint
Enginebay
-Install K&N Open Air Filter *fixed*
-Get and install E-fan.., the OEM one is broken and always on :S
-Install dumpvalve, its been lying here for too long already *done*
-Install the EBay inter cooler*done*
-Get a catch tank and install it
-A new Battery
-Install a wide band *In progress* JAW is partially soldered just need to get the wideband sender
-Install the chip/ get a new chip the one that was sold to me was useless apparently (they are made for each car on the dyno, getting one from another could work or blow ya engine to little pieces)
Interior
- Get a new dash or pain the old one (its cracked and some wood that did not came off nicly is still there, yugh)
- Glue the sealing, its still intact but saggy *In progress, new sealing is here but needs to be cleaned and installed*
- properly mount the steering wheel horn bit *fixed*
- install the Gaugepod with calibrated boost, oil pressure and temp gauge *In progress, waiting for the senders, wires and gauges are installed*
- fix the RPM meter
- Get the backlight of the gauges working again *fixed*
- Mount the fire extinguisher
Trunk:
-Secure the sub
-Secure the amp
-install the red neons in the amp
-fix that damn voice coming through the sub (its on momoblock and still the voices come through)
Under the car ect
-Fix leak in the exhaust / get a 3" one
-Foglights that will fit the SE kit *orederd, Or not...?*
-Install the Hausser Lowering springs
-RED Led undercar
-Repaint and attach the SE skirts