stillspoolin
New member
- Joined
- Aug 16, 2006
- Location
- San Antonio, Texas
sweet, could we do this to my block while the kit is in town?
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
sweet, could we do this to my block while the kit is in town?
My motor, '92 B230, did not have these till I used this kit. So pre-93 B230's don't have them, B230FT's might have them a bit earlier.One member posted a comment regarding pre 1993 b230 engines do not have these. I would like to know if this is true?
Yet another member mentioned about using the high-output oil pump using a different size drive gear to deliver more volumn and output. If a high output oil pump is needed this would be a very important detail that everyone needs to know about. Without a different oil pump the bottom end and even the valve train could be affected.
First of all, this was a very informative post regarding the squirter installation and it's simplicity. Secondly, I have worked in the diesel industry for many years and "piston-coolers" are a must to cool the underside of the piston and prevent a melt-down condition from sustained boost and internal combustion pressures and temps.
One member posted a comment regarding pre 1993 b230 engines do not have these. I would like to know if this is true?
Yet another member mentioned about using the high-output oil pump using a different size drive gear to deliver more volumn and output. If a high output oil pump is needed this would be a very important detail that everyone needs to know about. Without a different oil pump the bottom end and even the valve train could be affected.
All information would be great for everyone.
Keep up the great work gentlemen.
Jeff
Hello Jeff,
By the way, nobody here should be referred to as "gentlemen",
we're Turbobrickistas,
nancy:
i need the kit when its available.
i need the kit when its available.
The kit is still sitting at my house because the other two noobs in town can't make up their minds. So give John V a call, pay the deposit, and it'll be on its way to you.
sweet mod!
I am looking to do the same thing with VW 4 cyl blocks.
Could someone post a couple nice big clear pics of the bmw squirter by itself? Does it have a metal check ball on the galley end so that it only works under higher pressure?
Yep I chose the one second from the right...